– Missing or misaligned hole punch service check
– Hole punch box undetected service check
– Finisher door (HPU) undetected service check
– Output expander rear door undetected service check
– Output expander undetected service check
– Output expander bin error service check
– HCOE bin error service check
– HCOE undetected service check
– HCOE rear door undetected service check
Output option removals
– HCOE bin full flag removal
– Output expander drive gear removal
– Staple, hole punch finisher option removal
– Stapler cartridge access door removal
– Hole punch box removal
– Staple, hole punch left cover removal
– Staple, hole punch right cover removal
– Sensor (cartridge door interlock) removal
– Stapler door close limit switch removal
– Stapler carriage assembly removal
– Sensor (throat media present) removal
– Staple, hole punch latch removal
– Stapler controller PCBA removal
– Stapler main motor removal
– Stapler paddle motor removal
– Sensor (paddle motor HP) removal
– Stapler diverter motor removal
– Stapler diverter plunger assembly removal
– Stapler drive gear assembly removal
– Sensor (bin full send) removal
– Sensor (bin full receive) removal
– Staple, hole punch lower interface cable removal
– Media pusher assembly removal
– Standard output bin LED removal
– Sensor (finisher bin media present) removal
– Staple, hole punch top cover removal
– Sensor (right tamper motor HP) removal
– Sensor (left tamper motor HP) removal
– Stapler tamper assembly removal
– Tamper motor (right) removal
4063
Preface
35
To Next Page
Loading...
