FLIR Client 12 for PC / Mac
13
9. Click Play. The video stream will open in VLC Media Player.
If it does not connect, check the following:
• Check that the syntax on the RTSP address is correct.
• Make sure the system is connected to the network.
• If connecting over the Internet, make sure to use the remote IP address of the sys-
tem and that the RTSP port is open.
13.6.16 Configuring Motion Detection Settings
The system supports motion detection on any connected camera. You can determine the
sensitivity as well as the active area for motion detection per channel.
To enable and configure motion detection:
1. Click Remote Setting in the top-right corner of the window.
2. Under Settings, click Alarm to open the Motion tab.
3. Use the dropdown next to Channel to select a channel to configure motion detection
for.
4. Click the switch next to Enable to enable (
) or disable ( ) motion detection.
5. Use the dropdown next to Sensitivity to select a sensitivity level for motion events.
The lower the sensitivity value, the more movement is required to trigger motion
detection.
6. Use the dropdown next to Buzzer to select whether you would like the DVR to make
an alarm sound when motion is detected.
7. Click the switch next to Full Screen to enable (
) or disable ( ) full screen
viewing when motion is detected.
8. Use the dropdown next to Post Recording to set the amount of time the system will
record video for after motion is detected.
9. Click the switch next to Show Message to enable (
) or disable ( ) on-screen
messages when motion is detected.
#LX400086; r. 1.0/39246/39246; en-US
112
To Next Page
Loading...
Need help?
General