Playback9
9.5.1 Using the Smart Search Menu
1. Move Menu: Click-and-drag to move the Smart Search menu.
2. Configure Active Area: Click to set an active area for Smart Search. A red grid over-
lays the camera image. By default, the entire image is included in the active area.
Click-and-drag over areas of the image to remove the red grid overlay, which removes
that part of the image from the active area.
NOTE
The image on the far-left shows the default active area, covering the entire image. This means that
the camera will consider any motion in the image for a potential smart event. In the image on the far-
right, only motion occurring in front of the door or inside the house will be considered for smart
events, whereas motion near the patio furniture will not.
3. Reset Active Area: Reset to the default of using the entire image as the active area
for smart events.
4. Refresh Search: Search for smart events based on a custom active area.
5. Return to Playback Menu
9.6 Using Digital Zoom
Zoom in on an area of playback to enlarge a part of the image.
#LX400086; r. 1.0/39246/39246; en-US
30
To Next Page
Loading...
