What does In Phase Open mean on an LSIS Inverter?
The 'In Phase Open' message on your LSIS Inverter indicates that a 3-phase inverter input has one or more phases in an open circuit condition. This operates only when bit 2 of parameter Pr.05 is set to 1.
What does Over Voltage mean on an LSIS Inverter?
The 'Over Voltage' message on your LSIS Inverter means that the internal DC circuit voltage exceeds the specified value.
What does Over Current1 mean on an LSIS Inverter?
The 'Over Current1' message on your LSIS Inverter indicates that the inverter output current exceeds 200% of the rated current.
What does Ground Trip* mean on an LSIS Inverter?
The 'Ground Trip*' message on your LSIS Inverter indicates that a ground fault trip has occurred on the output side of the inverter, causing the current to exceed the specified value.
Why does my LSIS Inverter display Inverter OLT?
The 'Inverter OLT' message on your LSIS Inverter means the inverter has been protected from overload and resultant overheating, based on inverse time-limit thermal characteristics.
What does Low Voltage2 mean on an LSIS Inverter?
The 'Low Voltage2' message on your LSIS Inverter means that the internal DC circuit voltage is less than the specified value during inverter operation.
What does NTC Open mean on an LSIS Inverter?
The 'NTC Open' message on your LSIS Inverter indicates that an error has been detected in the temperature sensor of the Insulated Gate Bipolar Transistor (IGBT).
What does No Motor Trip mean on an LSIS Inverter?
The 'No Motor Trip' message on your LSIS Inverter indicates that the motor is not connected during inverter operation. This operates when parameter Pr.31 is set to 1.
What does Out Phase Open mean on an LSIS Inverter?
The 'Out Phase Open' message on your LSIS Inverter indicates that a 3-phase inverter output has one or more phases in an open circuit condition. This operates when bit 1 of parameter Pr.05 is set to 1.
What does Lost Command mean on an LSIS Inverter?
The 'Lost Command' message on your LSIS Inverter indicates that a frequency or operation command error has been detected during inverter operation by controllers other than the keypad.
General| Brand | LSIS |
|---|---|
| Model | LSLV-S100 |
| Category | Controller |
| Language | English |
To Next Page
