LSIS LSLV-S100 - Multi-Function Input Terminal Control

108
Learning Basic Features
Group
Code
Name
LCD Display
Parameter Setting
Setting Range
Unit
bA
04
2
nd
Command source
Cmd 2nd Src
0
Keypad
0–4
-
05
2
nd
Frequency reference
source
Freq 2nd Src 0 KeyPad-1 0–12 -
In
65–71
Px terminal configuration
Px Define
(Px: P1–P7)
15 2nd Source 0–54 -
* Displayed under DRV-06 in an LCD keypad.
2nd Operation Mode Setting Details
Code
Description
bA.04 Cmd 2nd Src
bA.05 Freq 2nd Src
If signals are provided to the multi-function terminal set as the 2
nd
command
source (2nd Source), the operation can be performed using the set values from
bA.04-05 instead of the set values from the drv and Frq codes in the Operation
group.
The 2nd command source settings cannot be changed while operating with the
1
st
command source (Main Source).
• When setting the multi-function terminal to the 2
nd
command source (2nd Source) and input (On)
the signal, operation state is changed because the frequency setting and the Operation command
will be changed to the 2
nd
command. Before shifting input to the multi-function terminal, ensure
that the 2
nd
command is correctly set. Note that if the deceleration time is too short or inertia of the
load is too high, an overvoltage fault trip may occur.
• Depending on the parameter settings, the inverter may stop operating when you switch the
command modes.
4.20 Multi-function Input Terminal Control
Filter time constants and the type of multi-function input terminals can be configured to improve
the response of input terminals
Group
Code
Name
LCD Display
Parameter Setting
Setting Range
Unit
In
85
Multi-function input
terminal On filter
DI On Delay
10
0–10000
ms
86
Multi-function input
terminal Off filter
DI Off Delay
3
0–10000
ms
87
Multi-function input
terminal selection
DI NC/NO Sel
0 0000*
-
-