LSIS LSLV-S100 - Learning to Use the Keypad; Group and Code Selection

47
Learning to Perform Basic Operations
3.2 Learning to Use the Keypad
The keypad enables movement between groups and codes. It also enables users to select and
configure functions. At code level, you can set parameter values to turn on or off specific functions,
or decide how the functions will be used. Refer to 8 Table of Functions on page 259
to find the
functions you need.
Confirm the correct values (or the correct range of the values), and then follow the examples
below to configure the inverter with the keypad.
3.2.1 Group and Code Selection
Follow the examples below to learn how to switch between groups and codes.
Step
Instruction
Keypad Display
1
Move to the group you
want using the [◀] and [▶]
keys.
2
Move up and down
through the codes using
the [▲] and [▼] keys until
you locate the code that
you require.
3
Press the [ENT] key to save
the change.
-