LSIS LSLV-S100 - 8 Table of Functions; Operation Group

Table of Functions
259
8 Table of Functions
This chapter lists all the function settings for S100 series inverter. Set the parameters required
according to the following references. If a set value input is out of range, the following messages
will be displayed on the keyboard. In these cases, the inverter will not operate with the [ENT] key.
• Set value not allocated: rd
• Set value repetition (multi-function input, PID reference, PID feedback related): OL
• Set value not allowed (select value, V2, I2): no
8.1 Operation Group
The Operation group is used only in the basic keypad mode. It will not be displayed on an LCD
keypad. If the LCD keypad is connected, the corresponding functions will be found in the
Drive(DRV) group.
SL: Sensorless vector control (dr.09) , I – IM Sensorless, P – PM Sensorless
*O/X: Write-enabled during operation, 7/L/A: Keypad/LCD keypad/Common
Code
Comm.
Address
Name
Keypad
Display
Setting Range
Initial Value
Property*
V/F
SL
Ref.
0h1F00
Target
frequency
0.00
0-Maximum
frequency(Hz)
0.00
O/7
O
I/P
p.48
-
0h1F01
Acceleration
time
ACC
0.0-600.0(s)
20.0
O/7
O
I/P
p.88
-
0h1F02
Deceleration
time
dEC
0.0-600.0(s)
30.0
O/7
O
I/P
p.88
-
0h1F03
Command
source
drv
0
Keypad
1:
Fx/Rx-1
X/7
O
I/P
p.80
1
Fx/Rx-1
2
Fx/Rx-2
3
Int 485
4
Field Bus
1
-
0h1F04
Frequency
reference
source
Frq
0
Keypad-1
0: Keypad-1
X/7
O
I/P
p.66
1
Keypad-2
2
V1
4
V2
5
I2
6
Int 485
8
Field Bus
1
Table of options are provided separately in the option manual.