LSIS LSLV-S100 - Actual Application Examples; Acceleration Time Configuration

51
Learning to Perform Basic Operations
Step
Instruction
Keypad Display
3
Press the [▲] or [▼] key to select code 90 (ESC key configuration),
and then press the [ENT] key.
Code dr.90 currently has an initial parameter value of, 0 (adjust to
the initial position).
4
Press the [▲] key to modify the value to 1 (Jog key) and then press
the [ENT] key.
The new parameter value will flash.
5
Press the [ENT] key again to save changes.
-
Note
• If the code dr. 90 (ESC key configuration) is set to 1 (JOG Key) or 2 (Local/Remote), the SET indicator
will flash when the [ESC] key is pressed.
• The factory default setting for code dr. 90 is 0 (move to the initial position). You can navigate back
to the initial position (code 0.00 of the Operation group) immediately, by pressing the [ESC] key
while configuring any codes in any groups.
3.3 Actual Application Examples
3.3.1 Acceleration Time Configuration
The following is an example demonstrating how to modify the ACC (Acceleration time) code value
(from 5.0 to 16.0) from the Operation group.
)
dr.90
!