LSIS LSLV-S100 - Jog Frequency Configuration; Initializing All Parameters

54
Learning to Perform Basic Operations
3.3.3 Jog Frequency Configuration
The following example demonstrates how to configure Jog Frequency by modifying code 11 in
the Drive group (Jog Frequency) from 10.00(Hz) to 20.00(Hz). You can configure the parameters for
different codes in any other group in exactly the same way.
Step
Instruction
Keypad Display
1
Go to code 11(Jog Frequency) in the Drive group.
2
Press the [ENT] key.
The current Jog Frequency value (10.00) for code dr.11 is displayed.
3
Press the [◀] key 3 times to move to the 10s place value.
Number ‘1’ at the 10s place position will flash.
4
Press the [▲] key to change the value to ‘2,’ to match the 10s
place value of the target value’20.00,’ and then press the [ENT]
key.
All parameter digits will flash on the display.
5
Press the [ENT] key once again to save the changes.
Code dr.11 will be displayed. The parameter change has been
completed.
3.3.4 Initializing All Parameters
The following example demonstrates parameter initialization using code dr.93 (Parameter
Initialization) in the Drive group. Once executed, parameter initialization will delete all modified
values for all codes and groups.
dr.11
10.0)
!0.00
@),))
dr.11