LSIS LSLV-S100 - Safe Operation Mode

Learning Advanced Features
131
To enable the 3-wire operation, the following circuit sequence is necessary. The minimum input
time (t) for 3-wire operation is 1ms, and the operation stops when both forward and reverse
operation commands are entered at the same time.
[Terminal connections for 3-wire operation]
[3-wire operation]
5.5 Safe Operation Mode
When the multi-function terminals are configured to operate in safe mode, operation commands
can be entered in the Safe operation mode only. Safe operation mode is used to safely and
carefully control the inverter through the multi-function terminals.
Group
Code
Name
LCD Display
Parameter Setting
Setting Range
Unit
Ad
70
Safe operation
selection
Run En Mode
1
DI Dependent
-
-
71
Safe operation stop
mode
Run Dis Stop
0
Free-Run
0-2
-
72
Safe operation
deceleration time
Q-Stop Time
5.0
0.0-600.0
sec
In
65-69
Px terminal
configuration
Px Define(Px: P1-
P5)
13
RUN Enable
-
-