Learning to Perform Basic Operations
3.1.2 Operation Keys
The following table lists the names and functions of the keypad’s operation keys.
[RUN] key Used to run the inverter (inputs a RUN command).
[STOP/RESET] key
STOP: stops the inverter.
RESET: resets the inverter following fault or failure condition.
,
[▲] key, [▼] key
Switch between codes, or to increase or decrease parameter
values.
,
[◀] key, [▶] key
Switch between groups, or to move the cursor during
parameter setup or modification.
[ENT] key
Used to select, confirm, or save a parameter value.
[ESC] key
A multi-function key used to configure different functions, such as:
• Jog operation
• Remote/Local mode switching
Cancellation of an input during parameter setup
Install a separate emergency stop switch in the circuit. The [STOP/RESET] key on the keypad works only
when the inverter has been configured to accept an input from the keypad.
To Next Page
Loading...
