LSIS LSLV-S100 - Easy Start on

186
Learning Advanced Features
Code
Description
4
Changing the value in ❸ will also change the value in ❹. If no
code is registered, ‘Empty Code’ will be displayed. Entering 0
cancels the settings.
5
The registered parameters are listed in the user group in U&M
mode. You can register one parameter multiple times if necessary.
For example, a parameter can be registered as code 2, code 11,
and more in the user group.
Follow the procedures below to delete parameters in the user group.
No.
Settings
1
Set CNF- 42 to 3(UserGrp SelKey). A icon will be displayed at
the top of the LCD display.
2
In the USR group in U&M mode, move the cursor to the code that
is to be deleted.
3
Press the [MULTI] key.
4
Move to YES on the deletion confirmation screen, and press the
[PROG/ENT] key.
5
Deletion completed.
CNF-25 UserGrp AllDel
Set to 1(Yes) to delete all registered parameters in the user group.
5.28 Easy Start On
Run Easy Start On to easily setup the basic motor parameters required to operate a motor in a
batch. Set CNF-61(Easy Start On) to 1( Yes) to activate the feature, initialize all parameters by setting
CNF-40 (Parameter Init) to 1 (All Grp), and restart the inverter to activate Easy Start On.
Group
Code
Name
LCD Display
Parameter Setting
Setting Range
Unit
CNF*
61
Parameter easy start settings
Easy Start On
1
Yes
-
-
*Available on LCD keypad only.
Easy Start On Setting Details
Code
Description
CNF-61 Easy Start On
Follow the procedures listed below to set parameter easy start.
No
Procedures
1
Set CNF-61 (Easy Start On) to 1( Yes).
2
Select 1(All Grp) in CNF-40 (Parameter Init) to initialize all
parameters in the inverter.
3
Restarting the inverter will activate the Easy Start On. Set the values
in the following screens on the LCD keypad. To escape from the Easy