LSIS LSLV-S100 - Setting Parameter Values

49
Learning to Perform Basic Operations
Step
Instruction
Keypad Display
5
Press the [▲] key to increase the number from ‘0’ to ‘9,’ the 10s
place digit of the destination, ’95.’
6
Press the [ENT] key.
Code dr.95 is displayed.
3.2.3 Setting Parameter Values
Enable or disable features by setting or modifying parameter values for different codes. Directly
enter setting values, such as frequency references, supply voltages, and motor speeds. Follow the
instructions below to learn to set or modify parameter values.
Step
Instruction
Keypad Display
1
Select the group and code to setup or modify
parameter settings, and then press the [ENT]
key.
The first number on the right side of the
display will flash.
2
Press the [◀] or [▶] key to move the cursor to
the number that you would like to modify.
3
Press the [▲] or [▼] key to adjust the value,
and then press the [ENT] key to confirm it.
The selected value will flash on the display.
4
Press the [ENT] key again to save the change.
-
95
dr.95
5.)