LSIS LSLV-S100 - Frequency Reference Configuration

52
Learning to Perform Basic Operations
Step
Instruction
Keypad Display
1
Ensure that the first code of the Operation group is selected, and
code 0.00 (Command Frequency) is displayed.
2
Press the [▲] key.
The display will change to the second code in the Operation
group, the ACC (Acceleration Time) code.
3
Press the [ENT] key.
The number ‘5.0’ will be displayed, with ‘0’ flashing. This indicates
that the current acceleration time is set to 5.0 seconds. The flashing
value is ready to be modified by using the keypad.
4
Press the [◀] key to change the first place value.
‘
5’ will be flashing now. This indicates the flashing value, ‘5’ is ready
to be modified.
5
Press the [▲] key to change the number ‘5’ into ‘6’, the first place
value of the target number ’16.’
6
Press the [◀] key to move to the 10s, place value.
The number in the 10s position, ‘0’ in ‘06’ will start to flash
7
Press the [▲] key to change the number from ‘0’ to ‘1’, to match
the 10s place value of the target number’16,’ and then press the
[ENT] key.
Both digits will flash on the display.
8
Press the [ENT] key once again to save changes.
‘ACC’ will be displayed. The change to the acceleration time setup
has been completed.
3.3.2 Frequency Reference Configuration
The following is an example to demonstrate configuring a frequency reference of 30.05 (Hz) from
the first code in the Operation group (0.00).
0.00
acc
5.)
%.0
^.0
)6.0
!^,)
acc