LSIS LSLV-S100 - Read, Write, and Save Parameters

208
Learning Protection Features
Code
Description
1
Forced-cool
Additional power is supplied to operate the cooling fan.
This provides extended operation at low speeds. Motors
designed for inverters typically have this design.
Pr.42 ETH 1 min
The amount of input current that can be continuously supplied to the motor
for 1 minute, based on the motor-rated current (bA.13).
Pr.43 ETH Cont
Sets the amount of current with the ETH function activated. The range below
details the set values that can be used during continuous operation without
the protection function.
6.1.2 Overload Early Warning and Trip
A warning or fault ‘trip’ (cutoff) occurs when the motor reaches an overload state, based on the
motor’s rated current. The amount of current for warnings and trips can be set separately.