LumaSMART
®
User Manual Index • 148
M
Maintenance 143
Malfunction or Service Request 10
Memory 25, 142
Modbus Input Status 90
Modbus Coil Status 89
Modbus Holding Register 90
Modbus Input Register 96
Modbus Protocol Testing 81
Modbus Register Map 89
Mounting and Installing the LumaSMART Controller
44
O
Operating Specifications 15
P
Power 15, 48
Power Connections 15, 47, 48
Power Supply 15, 48
Pre-Installation Planning 29
Probe Design 14, 26
Probes 15, 26, 30
Installation 34, 35, 38, 39
Testing the Probe Signal Strength 52, 71
Programmable Cooling Control 15
R
Relay and Control 55, 71
Relay Connections 15
Relay Module 15
Relay Modules 15
Relay Outputs 15, 50, 53, 55
S
SBC and Comm Board 15
Sensor Channel Diagnostic Screen 52, 54, 71
Sensor Installation Guidelines 35
Sensor Tip Placement 35
Serial Interface 15
Service Request 10
Setpoint 13
Shell Form Transformer 30, 38
Shipments to LumaSense for Repair 10
Software
Channels (Home) 53
Diagnostics 71
Communications and Protocol 71
Relay Testing/Simulations 71
Sensor Channel Diagnostics 71
Relay Status 53
Sensor Channel Diagnostics 54
Setup Menu 55
Administrator Tools 55
Analog Outputs 55
Channel Setup 55
Date & Time 55
Relay & Control 55
Transformer Info Setup 55
Temperatures Screen 54
Transformer Info 67
Software Administrator Tools 55
Administrator Setup 55
Change Authentication Code 55
Download Firmware 55
Entering the Authentication Code 55
System Components 15
System Organization 14
System Overview 13
System Status Relay 15
T
Tank Wall Plate (TWP) assembly 26
Installing the Tank Wall Adapter Plate 40
Installing the Tank Wall Plate Assembly 42
Technical Support 10
Temperature Sensor 14, 54
Testing the Probe Signal Strength 52, 54, 71
Theory of Operation 14, 15
Third Party Suppliers 145
Top Oil Measurement 31
U
Unpacking and Inspection 10
User Benefits 27
User Commands 141
To Previous Page
Loading...
Need help?
General