LumaSense LumaSMART User Manual

LumaSMART
®
User Manual Installation of the LumaSMART® Controller • 45
Wall-Mount LumaSMART (Back View)
4.1.2 Installing the Panel-Mount LumaSMART
The panel-mount LumaSMART is designed for mounting flush with a flat, vertical surface.
To install the panel-mount LumaSMART:
1. Determine where the LumaSMART is to be mounted.
2. The panel-mount version of the LumaSMART includes four universal mounting brackets. Mark the holes
for drilling.
3. Drill using an 8 mm (5/16 in) drill bit or tap the four holes in the wall upon which the LumaSMART is to be
mounted, matching the hole pattern drawing included with your system.
4. Mount the LumaSMART to the panel, using Red Head stud anchors and washers.
5. Connect the fiber optic extension cables to the LumaSMART as discussed in Section 4.2
Installing the
External Fiber Optic Extension Cable.
6. Connect the electrical wiring to the LumaSMART as discussed in Section 4.3 Installing the Electrical Wiring.
7. Test the LumaSMART using the instructions in Section 4.5 Testing the Probe Signal Strength.

LumaSense LumaSMART Specifications

General

Brand	LumaSense
Model	LumaSMART
Category	Controller
Language	English