LumaSMART
®
User Manual Using the Software • 53
5 Using the Software
5.1 Home Screen
The home screen displays a scrolling list of all the available probe channels. This view displays basic information
about each channel, such as temperature (or P.E. for probe error if a signal is not available) and channel name. All
temperatures are in Celsius. Channel statuses update every
10 seconds.
Channels (Home) Screen
Note: To return to this screen at any time, click the Home button:
To set a channel’s name or enable/disable it, go to Menu > Setup > Channel Setup. See Section 5.2.1 Setup for
more setup information.
To set the speed of temperature channel rotation for this screen and the time before the backlight turns off, go to
Menu > Display. See Section 5.2.4 Display
for more information.
When a probe is properly connected and not in an alarm state, it will display its current temperature reading.
When a probe is not connected properly or has become damaged, it will display “P.E.” If the module that monitors
a probe fails, “N.C.” (No Communication) will be shown. When a probe is disabled, it will display “DSBL”.
5.1.1 Viewing All Relays
The View All Relays screen contains a scrollable list of all relays and their current status. A Disabled status means
that the relay must be activated and configured via the Setup menu. See Section 5.2.1.4 for Relay Setup
.
To Next Page
Loading...
Need help?
General