LumaSMART
®
User Manual Contents • vi
6.5.4 Modbus Input Register .......................................................................................................... 96
7 IEC 61850 Protocol Testing ..................................................................................................................... 99
7.1.1 Test Setup.............................................................................................................................. 99
7.2 Configuring IEC 61850 in LumaSMART and TMW Hammer ......................................................... 100
7.3 Connecting the LumaSMART and TMW Hammer ....................................................................... 102
7.4 Sample Relay Setup .................................................................................................................... 103
7.5 Report Control ............................................................................................................................ 105
7.6 IEC61580 Channel Temperature Alarm ....................................................................................... 106
7.6.1 Example for Channel 4 alarm .............................................................................................. 106
7.7 IEC61850 Channel Signal Strength Alarm .................................................................................... 108
7.7.1 Example for Channel 4 alarm .............................................................................................. 108
7.8 IEC61580 Register Maps ............................................................................................................. 109
7.8.1 IEC61850 Temperature Channel Control and Supervision .................................................. 109
7.8.2 IEC61850 Relay Channel Control and Supervision .............................................................. 111
7.8.3 IEC61850 FOT Setup and Status Monitoring ....................................................................... 112
7.8.4 IEC61850 System Status Relay Report ................................................................................ 113
7.8.5 IEC61850 General System Configuration Information ........................................................ 114
7.8.6 IEC61850 Report Contents - Temperatures and Relays ...................................................... 115
7.8.7 IEC61850 Reports Channel Temperature and Probe Signal Strength Alarms ..................... 116
7.8.8 IEC61850 Probe Signal Strength levels ................................................................................ 116
8 DNP3 Protocol Testing ......................................................................................................................... 117
8.1 Configuring DNP3 in LumaSMART (Ethernet TCP/IP) .................................................................. 118
8.2 Testing Harness Window Components ....................................................................................... 119
8.3 DNP3 Enable Unsolicited Reports ............................................................................................... 121
8.4 Binary Inputs Data ...................................................................................................................... 121
8.5 Binary Outputs ........................................................................................................................... 122
8.6 Analog Inputs ............................................................................................................................. 124
8.7 Analog Output Statuses .............................................................................................................. 126
8.7.1 Configuring FOT Analog Outputs ......................................................................................... 126
8.7.2 Configuring Relay Operation ............................................................................................... 128
8.8 DNP3 Register Map .................................................................................................................... 131
8.8.1 DNP 3 Binary Output Map ................................................................................................... 131
8.8.2 DNP 3 Binary Input Map ...................................................................................................... 132
8.8.3 DNP 3 Analog Output Map .................................................................................................. 133
8.8.4 DNP 3 Analog Input Map ..................................................................................................... 137
9 Data Manager ...................................................................................................................................... 139
9.1 Data Report Content .................................................................................................................. 139
9.2 Data Retrieval ............................................................................................................................ 139
9.3 Operation During Data Retrieval Mode ...................................................................................... 140
10 User Commands ................................................................................................................................... 141
10.1 Command Rules, Syntax, and Returns ........................................................................................ 141
10.2 rtrv Command ............................................................................................................................ 142
11 Maintenance ........................................................................................................................................ 143
11.1 Battery Replacement .................................................................................................................. 143
To Next Page
Loading...
Need help?
General