– Programming Manual 7
13.3.1. Programming wheel vibration tolerance limits .................................................................. 81
13.3.2. Programming a limit on acceleration value....................................................................... 83
13.3.3. Type of balancing algorithm..............................................................................................83
13.3.4. Programming asymmetric filter on vibration signal ................................................. 84
13.4. Programming the integrated Gap&Crash .......................................................85
13.4.1. Selecting a Frequency Band............................................................................................. 85
13.4.2. Gain selection................................................................................................................... 86
13.4.3. Programming Gap control data ............................................................................... 87
13.4.4. Programming Crash control data ........................................................................... 90
13.5. Supervision programming ..............................................................................92
14. I/O TEST ..............................................................................................................94
14.1. I/O Byte test.............................................................................................................95
14.2. I/O bit test ................................................................................................................98
14.3. Field Bus test.........................................................................................................100
15. MOTORS TEST ...................................................................................................103
15.1. Value of the temperature between transmitter and receiver ..................................105
16. VOLTAGE SETUP ..............................................................................................106
16.1. Viewing the receiver supply voltage.......................................................................107
16.1.1. RPM sensor checking..................................................................................................... 108
16.2. Check voltage under load......................................................................................108
17. HEADS CONNECTION ...................................................................................110
17.1. Connection of balancing channels.........................................................................111
17.2. Characteristics of heads connected to balancing channels ...................................112
18. BALANCING HEADS INFO .............................................................................113
18.1. Parameters for manual balancing with weights .............................................115
18.1.1. Wheel rotation direction (RPM) / Angle evaluation direction (°)...................................... 115
18.1.2. Number of holes ............................................................................................................. 116
18.1.3. Weight value................................................................................................................... 117
18.1.3.1. Copy data ................................................................................................................................118
18.1.4. Test weight ..................................................................................................................... 118
18.2. Heads parameterization ................................................................................119
18.3. Heads programming .....................................................................................120
18.4. Balancing algorithm parameters ....................................................................120
19. MACHINE DATA ..................................................................................................122
19.1. Selecting unit of measure and language ......................................................124
19.1.1. Selecting unit of measure (micron/inch) ......................................................................... 124
19.1.2. Selecting the language................................................................................................... 124
To Next Page
Loading...