marposs P7WB - Page 6

6 – Programming Manual
8.4. “External Info” folder ......................................................................................... 36
9. MENU MAPS (AUTOMATIC MODE ) ......................................................................... 37
9.1. “View” folder ...................................................................................................... 37
9.2. “Inputs & Outputs” folder ................................................................................... 38
10. UNIT SET-UP ........................................................................................................ 39
10.1. Home position ................................................................................................. 41
10.2. Manual balancing procedure with weights ...................................................... 44
10.2.1. RPM sensor control ..........................................................................................................45
10.2.2. Manual balancing procedure with fixed weights/variable angles ...................................... 46
10.2.3. Manual balancing procedure with variable weights /fixed angles ..................................... 50
10.3. Procedure for frequency spectral analysis ...................................................... 52
10.4. Archive of frequency spectral analysis .............................................................. 55
11. MEASUREMENT ADJUSTMENT .................................................................. 57
11.1. Manual balancing ........................................................................................... 58
11.2. Automatic balancing ........................................................................................ 61
11.3. Double automatic Balancing ........................................................................... 62
11.4. View acceleration ........................................................................................... 63
11.5. Noise measurement ........................................................................................ 64
11.6. Gap&Crash graphic representation and dynamic set-up ................................. 65
11.6.1. Time base ......................................................................................................................... 67
11.6.2. Vertical scale..................................................................................................................... 67
11.6.3. Trace Source and Position................................................................................................69
11.6.4. Numerical values ..............................................................................................................69
11.6.5. Gap&Crash graphical thresholds......................................................................................70
12. VIEW DATA ......................................................................................................... 71
12.1. Viewing data relevant to set (wheel/cycle) .............................................................. 73
12.2. Viewing unbalance limit values ............................................................................... 73
12.2.1. Viewing asymmetric filter on vibration signal .................................................................... 74
12.3. Viewing data of integrated Gap & Crash function.................................................... 75
12.3.1. Gap control data ..................................................................................................... 76
12.3.2. Crash control data .................................................................................................. 76
12.4. Viewing supervision data ........................................................................................ 77
13. PROGRAMMING ................................................................................................. 78
13.1. Programming a simple set (1 logical channel) ................................................ 79
13.2. Programming a double set (2 logical channels) ........................................... 80
13.3. Programming unbalance limit values ............................................................. 81