MD Helicopters MD Explorer - Page 65

CSP−900RMM−2MD Helicopters, Inc.
ROTORCRAFT MAINTENANCE MANUAL
Page iii
Revision 34
05 Contents
TABLE OF CONTENTS (Cont.)
Para/Figure/Table Title Page
A. Sudden Stoppage of the Main Rotor or Rotor Drive System 201..................
B. Sudden Stoppage of the Anti-Torque Fan 201..................................
4. Overtorque 201...............................................................
5. Overspeed 202................................................................
6. Lightning Strike 202...........................................................
7. Engine Out/Low Rotor Functional Check 202....................................
8. Unscheduled, Conditional Inspection Tables 202.................................
Table 201. Hard Landing, Level I, Conditional Inspection 203..................
Table 202. Hard Landing, Level II, Conditional Inspection 209.................
Table 203. Main Rotor Sudden Stoppage, Conditional Inspection 217............
Table 204. Anti-Torque Fan Sudden Stoppage, Conditional Inspection 223......
Table 205. Overtorque Up to 110% (average input),
Conditional Inspection Both Engines Operative 227.................
Table 206. Overtorque Above 110% (Average Input),
Conditional Inspection Both Engines Operative 229.................
Table 207. Transmission and Drive System Overtorque,
Conditional Inspection, Single Engine Operation 233................
Table 208. Transmission and Drive System Overtorque (900 CONFIG),
Conditional Inspection. Both Engines Operative,
8% Maximum Engine Torque Differential 235......................
Table 209. Transmission and Drive System Overtorque (902 CONFIG),
Conditional Inspection. Both Engines Operative,
8% Maximum Engine Torque Differential 239......................
Table 210. Transmission and Drive System Overtorque,
Conditional Inspection. Both Engines Operative,
Greater Than 8% Engine Torque Differential 247...................
Table 211. Main Rotor Overspeed, 109 to 110% NR, Power Off,
Conditional Inspection 249........................................
Table 212. Main Rotor Overspeed, 106 to 110% NR, Power On,
Conditional Inspection 251........................................
Table 213. Main Rotor Overspeed, 111 to 114% NR, Power Off,
Conditional Inspection 255........................................
Table 214. Main Rotor Overspeed, 111 to 114% NR, Power On,
Conditional Inspection 259........................................
Table 215. Main Rotor Overspeed, Over 114% NR, Power Off,
Conditional Inspection 263........................................
Table 216. Main Rotor Overspeed, Over 114% NR, Power On,
Conditional Inspection 265........................................
Table 217. Main Rotor High Vibration During Startup or Shutdown
At 35 To 40% NR 267..............................................