Chapter 3 Cutting
108
Pausing Cutting
1
Press [LOCAL] while cutting is in progress.
• Cutting is paused.
• If data is being sent from a PC, data transmission is paused at the PC.
2
Press [REMOTE].
• Cutting resumes.
• No other functions can be executed while printing is paused.
Stopping Cutting (Data Clear)
1
On the LOCAL mode screen, select [DATA CLEAR].
width:1340mm
DATA CLEARADJUST
LOCAL
2
Press the [ENTER] key to clear the received data.
• The receive buffer is not cleared.
Retracting the Cutter Unit
When cutting or printing-with-a-pen is completed, the cutter unit is positioned on the platen. To check the
cutting result or to set new media, retract the cutter unit from the platen.
1
On the LOCAL mode screen, select [TEST CUT].
width:1340mm
PRTOOL
TEST CUT
LOCAL
2
Select [Cut Head Move/Retract], then press the [ENTER] key.
• If the cutter unit is not connected to the carriage, it moves to the station to connect to the carriage.
• If the cutter unit is connected to the carriage, detach the carriage and move it to the
maintenance space on the left side.