Chapter 2 Printing
This chapter
This chapter describes printing procedures and settings.
Print Process ...................................................52
Adjust Print Head Height .................................55
Adjust the Pinch Roller Positions. ...................56
1,600 mm Size ........................................... 57
1,300 mm Size ........................................... 58
Load the media................................................59
Media ......................................................... 59
Take-up Unit............................................... 60
Feeding unit ............................................... 64
Loading the Roll Media .............................. 67
Setting Leaf Media ..................................... 72
Registering the Media ................................ 75
Setting the Pressure and Number of Pinch
Rollers to Use..................................................77
Setting the Heater Temperature......................78
Test Printing .....................................................79
Changing the Layout Direction for Test
Printing.........................................................79
Ejection Failures ..........................................80
Head Cleaning..................................................81
Feed Correction................................................82
Feed Correction Procedure..........................82
Correcting the Drop Position ............................84
Drop Position Correction Procedure ............84
Preparing RIP data...........................................86
Printing .............................................................88
Changing the Origin .....................................88
Starting Printing ...........................................89
Stopping Printing (Data Clear) .....................90
Cutting the media .............................................91
V-shaped Cutting .........................................91
To Next Page
Loading...
Need help?
General
