Chapter 3 Cutting
96
3.2 Installing Cutting Tools
This machine can be used with the following tools:
• Cutter (for cutting media)
Used to cut the printed image on media or to cut characters with the cutting sheet. "Using the
Cutter"(P. 96)
• Pen (ballpoint pen)
Used to adjust register marks This machine can be used with a ballpoint pen or cartridge refill. "Using
a Pen"(P. 101)
Using the Cutter
Installing the Cutter in the Cutter Holder
Be careful to keep the cutter from falling into a gap in this machine. We recommend replacing the cutter on
the media so you can easily pick up the cutter blade if it falls.
• Avoid touching the cutter blade. Failure to do so may result in injury.
• Do not shake or swing the cutter holder. Doing so may cause the blade to come off.
• Avoid storing this product in locations accessible to children.
• When disposing of the product, contact an industrial waste disposal operator or dispose of the
product in accordance with the local laws and regulations.
1
Remove the cap from the cutter holder.
• Turn in the direction indicated by the arrow in the picture.
2
Insert the cutter into the cutter holder.
• Use tweezers to insert the cutter.
3
Fix the cap by turning in the direction indicated by the arrow in the picture.