Chapter 8 Troubleshooting
233
Message Cause Corrective action
Ink Near End • Ink levels are low. • The ink will run out soon. Have new ink
ready. "When Ink Near End is
Displayed"(P. 45)
Non Ink IC • No ink IC chip was
detected.
1. Insert the ink IC chip. "Replacing
Ink"(P. 46)
2. Check to confirm the ink IC chip was
inserted correctly. "Mounting the
ink"(P. 49)
3. Turn off the power on the machine and turn
it on after a while.
Wrong Ink IC • An error occurred with the
information on the ink IC
chip.
1. Check to confirm the ink IC chip was
inserted correctly. "Mounting the
ink"(P. 49)
2. Turn off the power on the machine and turn
it on after a while.
3. Replace with new ink. "Replacing
Ink"(P. 46)
Ink Color • The ink color registered
on the IC chip is different
from the ink color filled.
• Insert an ink IC chip for the correct ink
color. "Mounting the ink"(P. 49)
Ink Type • The ink type registered on
the IC chip is different
from the ink type filled.
• Insert an ink IC chip for the correct ink
type. "Mounting the ink"(P. 49)
Expiration Near • The ink has expired. • Replace with new ink or use up as
quickly as possible. Printing is possible.
"When Ink End is Displayed"(P. 45)
Expiration Over • The ink is two months
past its expiration date
and cannot be used.
• Replace with new ink. Printing is not
possible. "When Ink End is
Displayed"(P. 45)
Error Message
Error
number
Message Cause Corrective action
04 PARAM ROM • A problem was detected
with the main PCB.
• Turn off the power on the machine
and turn it on after a while.
108 HD THERMIS[12] • A problem was detected
with print head
temperature control.
108 HD CONNECT[12] • A problem was detected
with the print head
connection.
108 HD MEM EMP[12] • A problem was detected
with the print head.
10e FROM CLEAR • A problem was detected
with the main PCB.
10f FROM WRITE
115 PCB MAIN-F1
122 CHECK:SDRAM • A problem was detected
with the SDRAM.
122 PRAM NONE
8
To Next Page
Loading...
Need help?
General
