Chapter 1 Before Use
40
Color Status Overview
Off Connected via a network other than 1000BASE-T
• 1,000 Mbps is not supported if only the orange lamp is illuminated or
flashing. Check the specifications for the PC, peripheral devices, and
cable.
Orange Illuminated Linked up (connected).
Flashing Data being received
Off Link down (not connected)
Using a USB Cable
Connect a PC to this product using a USB interface cable.
• Do not unplug the cable while data is being transferred.
• Use RIP software that supports the USB interface.
• If the PC does not have a USB port, contact your local distributor, our sales office, or service
center.
• When a USB cable is used, data may be transferred to the machine too slowly, causing the
carriage to pause at the left or right end.
l
USB Connection Precautions
• When connecting more than one 330 series to a PC
– If the PC has more than one USB port, try connecting to a different USB port to check whether the
product is correctly recognized. If the product is still unrecognized even when connected to a
different USB port, use a commercially-available USB active repeater cable.
• When extending the USB cable
– Use a commercially-available USB active repeater cable. However, make sure that the combined
length of the USB cable and the USB active repeater cable does not exceed 20 m.
– If the USB cable is extended, this may reduce the data transfer speed to the machine, causing the
carriage to pause at the left-hand or right-hand end during printing.
• USB high-speed mode peripheral devices
– It may not be possible to recognize USB peripheral devices if USB high-speed mode peripheral
devices (e.g., USB memory, USB HDD devices) are connected to the PC to which the product is
connected. If external USB hard disk drives or other similar devices are connected, this may reduce
the data transfer speed to the machine, causing the carriage to pause at the left-hand or right-hand
end during printing.
• Unplugging USB memory devices
– When unplugging USB memory devices from the PC to which this product is connected, use "Stop"
in "Safely removing hardware" before unplugging. Otherwise, an [ERROR 201 Command Error] will
occur.
To Next Page
Loading...
Need help?
General
