Chapter 7 Maintenance
189
5
Clean both sides of the media cutter.
• Wipe off any adhesive paste, ink and dust adhering using a cleaning stick moistened with
industrial alcohol. Wipe off the maintenance liquid. Make sure none remains.
6
Check the position of the media cutter.
• Lift up the media cutter by hand if it has dropped down.
7
Once cleaning is complete, close the cover, then press the [ENTER] key.
Media Holder Cleaning
Continuing to use the dirty platen will prevent proper feeding of the media. It will also cause dried ink and
attached dust to rub against the head nozzle surface and lead to ejection failures (e.g., nozzle clogging or
deflection).
• Turn off the main power supply and unplug the power cable before carrying out maintenance.
• Do not allow liquids to get inside the machine. Otherwise there is a risk of failure, electric shock,
or fire.
• For heavy soiling, wipe using a soft cloth soaked in diluted neutral detergent and thoroughly
wrung out.
7
To Next Page
Loading...
Need help?
General
