This is used to check for nozzle clogging before printing starts. Sets whether to perform maintenance
functions automatically if nozzle clogging is detected.
If ≥ the set value
[Printing Check]
ON
The nozzles are not checked.
OFF
Performs nozzle recovery automatically.
Nozzle check (nozzle clogging detection)
Continue Printing
If less than the set value
[Judgment Condition] setting for nozzle clogging
detection
[Nozzle Recovery] (cleaning followed by nozzle
checking)
* Repeated by [Retry Count] cycles.
[Judgment Condition] setting for nozzle clogging
detection
Stop Printing
If ≥ the set value
[Auto Nozzle Recovery]
ON
OFF
If less than the set value
To Next Page
Loading...
Need help?
General
