Chapter 8 Troubleshooting
242
Error
number
Message Cause Corrective action
6. Check to confirm there are no errors in
the mark detection settings.
7. If the area around the register marks is
filled in, set [Mark Detect] > [Mark
FillUp] setting to "ON".
C37 Mark Org • The mark detection result
shows that the register
marks were detected
outside the plotting range.
• Change the layout by referring to
the following: "Reading Range
of Register Marks"(P. 115)
C60 PenEncoder • Unable to detect pen
height.
• Turn off the power on the machine
and turn it on after a while.
C61 Pen Stroke • The pen height is
incorrect.
1. Make sure the pen line rubber is not
worn or deformed and remains intact.
2. Check to confirm nothing adheres to the
pen line rubber.
3. After installing the pen in a
commercially available pen holder,
check to confirm the installed position is
correct.
C63 Cutter Head • The cutter vertical
movement is slow.
• Turn off the power on the machine
and turn it on after a while.
d1b COM VOLT[12] • A problem was detected
with the HDCE PCB
voltage.
• Turn off the power on the machine
and turn it on after a while.
SYSTEM HALT
• If a SYSTEM HALT number is displayed, Turn off the power on the machine and turn it on after
a while.
To Next Page
Loading...
Need help?
General
