Chapter 1 Before Use
37
2
Press the [END/POWER] key to turn on power.
• The firmware version appears on the display, and the initial operation is executed. The machine
will then enter the Media Select mode, and is ready for use.
3
Turn on the power for the connected PC.
• Close the front cover and maintenance covers. Leaving any of the covers open will disable the
automatic maintenance function (including nozzle clogging prevention function and waste ink
draining channel cleaning function). This will increase the risk of failure or ejection failures (e.g.,
nozzle clogging or deflection).
Turning Off the Power
• Check the following when turning off power:
(1) The front cover and maintenance covers are closed.
• Leaving any of the covers open will disable the automatic maintenance function (including
nozzle clogging prevention function and waste ink draining channel cleaning function).
(2) The carriage has returned to the capping station.
• If not, the print head nozzle may dry out, resulting in ejection failures (e.g., nozzle clogging
or deflection).
(3) Data is not being received
(4) No errors have occurred.
• "Problems Causing Messages to Appear"(P. 231)
1
Turn off the power to the PC connected.
2
Hold down the [END/ POWER] key.
• A power off confirmation screen appears. Press the [ENTER] key to turn the power off.
1
To Next Page
Loading...
Need help?
General
