Chapter 1 Before Use
36
1.2 Connecting the Power Cable
1
Check to confirm that the main power supply is turned off.
2
Insert the cable band to the machine.
3
Plug the power cable into the inlet of the machine.
4
Secure the power cable to the cable band.
• Pass the power cable through the clamp and clamp until it clicks into place.
5
Plug the power plug into the power outlet.
• Do not handle the power plug with wet hands. Disregarding this precaution may result in
electric shock.
Turning On the Power
1
Check to confirm that the main power supply is turned on.
• If the main power supply switch is not turned on, set to "I".
[JV/CJV] [TS]
Heater power supply switch
Main power switch Main power switch