Chapter 1 Before Use
39
1.3 Connecting a PC to the Product
Connect the machine to the RIP PC. The following cables can be used:
1. "Using a LAN Cable"(P. 39) (Recommended)
2. "Using a USB Cable"(P. 40)
• When a USB cable is used, data may be transferred to the machine too slowly, causing the
carriage to pause at the left or right end.
Using a LAN Cable
Connect a PC to this product using a LAN cable. Insert a LAN cable until it engages with a click.
• Do not unplug the cable while data is being transferred.
l
Network Connection Precautions
Make sure the network is set up as follows: Printing is not possible if the network is not set up correctly.
• Use a Category 6 or higher LAN cable.
• The PC used to transfer print data must be located on the same network as this product. This product
cannot be connected via a router.
• Use a 1000BASE-T compatible computer or switching hub. Printing requires 1000BASE-T support.
l
Checking the LAN connection
1
Check the display on this product.
• Local guidance can be used for checking. "Displaying Machine Information (Local
Guidance)"(P. 35) Printing is not possible if "100Mbps", "10Mbps", or "No Connect" is displayed.
INFORMATION
LAN Status 1000Mbps
2
Check the lamp on the LAN connector.
• The LAN connector lamp illuminates when the machine is running.
Color Status Overview
Green Illuminated Connected via 1000BASE-T
1
To Next Page
Loading...
Need help?
General
