MIMAKI JV330 Series User Manual

Chapter 8 Troubleshooting
235
Error
number
Message Cause Corrective action
1d8 HEAD XHOT[12] • A problem was detected
with the print head.
1e6 PRAM Size Shortage • Insufficient memory
201 Command Error • Data other than print (RIP)
data was received, or a
problem was detected
with the print (RIP) data
received.
1. Clear the data and resend.
2. Check the USB/Ether cable connection.
"Connecting a PC to the
Product"(P. 39)
3. Use a compatible cable.
"Connecting a PC to the Product"(P. 39)
4. Turn off the power on the machine and
turn it on after a while.
202 Parameter Error • A problem was detected
with the print (RIP) data
received.
206 Print Mode Error • Print (RIP) data was
received with print
parameters that do not
allow printing.
• Change the output parameters and
profile using RIP software.
20A Driver Version • Printing is not possible
because the Mimaki driver
version is old.
• Install the latest Mimaki driver
available from:
https://mimaki.com/download/
inkjet.html
303 PCB MAIN ET • A problem was detected
with the main PCB.
1. Turn off the power on the machine and
turn it on after a while.
304 USB INIT ERR • A problem was detected
with the USB cable
connection.
1. Check the USB cable connection.
"Using a USB Cable"(P. 40)
2. Use a compatible cable. "Using a
USB Cable"(P. 40)
3. Turn off the power on the machine and
turn it on after a while.
305 USB TIME OUT
315 No resp from
XY Slitter
• Unable to detect a
response from the XY
slitter.
1. Check to confirm that the XY slitter
cable is connected to the machine.
2. Select [MENU] > [Function Setting] > [
Finisher] > [None].
3. Select [MENU] > [Function Setting] >
[Finisher] > [XY Slitter].
316 XYSlitter
transmit error
• A problem was detected
with the transmission data
sent to the XY slitter.
• Turn off the power on the machine
and turn it on after a while.
317 XYSlitter
response error
• A problem was detected
with the response data
from the XY slitter.
318 SDcard Connection
ERR
• A problem was detected
with the SD card.
1. Turn off the power on the machine and
turn it on after a while.
401 Motor X • The X motor was
overloaded.
1. Check to confirm the media is loaded
correctly. "Load the media."(P. 59)
8

MIMAKI JV330 Series Specifications

General

Brand	MIMAKI
Model	JV330 Series
Category	Printer
Language	English