Chapter 2 Printing
83
• Once adjustment is complete, the medium will be fed to the print origin. Sagging may
occur in the rear roll medium. Rewind roll media by hand to eliminate any sagging.
Correcting the Media Feed During Printing
You can also correct the media feed amount in REMOTE mode or during printing.
1
Press [ADJUST] in REMOTE mode or during printing.
2
Enter the correction value, then press the [ENTER] key.
• Correction value: -9999 to 9999
• The value entered here will be updated immediately.
2
To Next Page
Loading...
Need help?
General
