Mindray DC-3 User Manual

Special Imaging Modes
11-10
11.1.3.3 Parameters Setup
Open the 3D/4D Image Preset interface via 『Setup』key Æ [Setup] Æ[Image Preset]
Æ[3D/4D], you can set parameters to your preference.
The main presetting page is shown as follows:
Select the probe
Select a probe model in the drop-down list .
General parameters setup
z Disp Format: to set the image display format in 3D image viewing status.
z Tool: To set the cut tool in image cutting mode.
z Edit Depth: To set the cut depth in image cutting mode.
z MPR Line: to set the display manner of MPR Line in image rendering mode.
Parameter package setup
The system provides 5 parameter packages for each mode. Parameter packages of
each mode are independent. Each parameter package includes a set of 3D/4D imaging
parameters. You can use one of them.
Click
button directly to enter the parameter package setup interface.
Or check the box ahead of User Define, then click the parameter package button to
enter the parameter package setup interface.

Mindray DC-3 Specifications

General

Brand	Mindray
Model	DC-3
Category	Medical Equipment
Language	English