Image Modes
10-12
Acoustic Power
The acoustic power refers to ultrasound power transmitted from the transducer. You
should perform exams according to actual situation and ALARA Principle.
z Click [A. Power] item in the menu to select among percentages.
z The AP value is also displayed at the top of the screen.
B Image Display
z
Click [B Image Display] item in the menu.
z Select [On] or [Off] to turn on or off the B Mode image display as live Color remains
active.
2. Optimizing Color Images
Color gain
z Rotate the [iTouch] key located on the right side of the control panel.
z The gain value is displayed on the image parameter area.
Flow State
z Click [Flow State] item in the menu.
z Select [Flow State] among L, M and H.
Steer
The Steer feature is used to adjust the RoI of color flow with different angles but with
immobility of the linear transducer.
z Click [Steer] item in the menu.
z Change the value.
z This feature is valid only for linear transducers.
Invert
The color bar can automatically invert when the color flow is steered to a certain angle,
thus accommodating operator’s habit of distinguishing flow direction. However, you can
also invert the color bar manually.
To invert the color bar automatically, you need to set it up beforehand.
z Press [Setup] key to show the [Setup] menu.
z Click [System] item to open the [System] screen.
z Click [Image Preset] tab to open [Image Preset] page.
z Check [Auto Invert] item in the [Image] region.
To invert the color bar manually:
z Click [Invert] item in the menu.
z Select [On] or [Off] to invert the color bar.
Priority
The Priority feature is used to show the flow priority displayed.
z Click [Priority] item in the menu.
z Select among 0% and 100% in increments of 10%.
To Next Page
Loading...
Need help?
General
