Image Modes
10-13
Packet Size
This feature is used to adjust the accuracy of color flow.
z Click [Packet Size] item in the menu.
z Select among 0, 1, 2 and 3.
Color IP
z Click [Color IP] item in the menu.
z Select among 1 through 8.
z The Color IP value selected is also displayed in the image parameter area.
Map
This feature indicates the display effect of color image.
z Click [Map] item in the menu.
z Select among 1 through 11.
z The Color bar is changed with the Map value change.
Wall Filter
This feature is used to filter the speed signals of the low speed flow.
z Click [Wall Filter] item in the menu.
z Select [WF] values.
Line Density
z Click [Line Density] item in the menu.
z Select between Low and High.
z Note: Changing Line Density will change B Mode frame rate (higher line density /
lower frame rate, lower line density / higher frame rate).
Smooth
This feature is used to reject noise and smooth the image.
z Click [Smooth] item in the menu.
z Select among 0 through 4. The smaller the value, the smaller the smooth extent.
The bigger the value, the bigger the smooth extent.
Persistence
This feature is used for temporal smooth of the image.
z Click [Persistence] item in the menu.
z Select among 0 through 4.
Contrast
This feature refers to contrast of color maps.
z Click [Contrast] item in the menu.
z Select among 0 through 3. The smaller the value, the smaller the contrast. The
bigger the value, the bigger the contrast.
To Next Page
Loading...
Need help?
General
