Chapter 5: Installation
Upgrade Scenarios
Page 5-162 Inter-Tel
®
5000 Installation Manual – Issue 2.4, May 2008
3. Using the menus, set the ICP and TFTP server address to be the NATed address of the
Inter-Tel 5000 base server.
4. Allow the endpoint to boot using DHCP, download the latest code and come online.
5. Power down the endpoint and deliver it to the user. The user simply plugs it in for it to
boot up and begin working.
6. Continue to the Inter-Tel 5000 Features and Programming Guide (part no: 580.8006) for
information on programming endpoints or other features in this release.
Upgrade Scenarios
Table 5-23 summarizes the possible upgrade options and identifies the appropriate process and
applicable procedures to use when upgrading your Inter-Tel 5000 platform.
Table 5-23. Possible Upgrade Scenarios for Inter-Tel 5000 v2.0 or Later
From Existing To Desired Result
Process and Procedures to Use
System Version System Version
CS-5200 1.1 CS-5200 2.x “Upgrading Only Software” on page 5-163
1.2 2.x
CS-5200 1.1 CS-5400 2.x “Upgrading from CS-5200 v1.x or v2.x to CS-5400 v2.x” on page 5-
164
1.2 2.x
2.0 2.x
CS-5200 1.1 CS-5600 2.x 1. Read “Upgrading from CS-5200 v1.x to CS-5600 v2.x” on page 5-
165.
2. Carry out “Upgrading from CS-5200 v1.x or v2.x to CS-5400 v2.x”
on page 5-164.
3. Carry out “Upgrading from CS-5400 v1.x or v2.x to CS-5600 v2.x”
on page 5-165
.
1.2 2.x
2.0 2.x
CS-5400 1.1 CS-5400 2.x “Upgrading Only Software” on page 5-163
1.2 2.x
CS-5400 1.1 CS-5600 2.x “Upgrading from CS-5200 v1.x or v2.x to CS-5400 v2.x” on page 5-
164
1.2 2.x
2.0 2.x
CS-5600 2.0 CS-5600 2.x “Upgrading Only Software” on page 5-163
To Next Page
Loading...
