Chapter 6: Reference
SIP and ITP Default Feature Codes
Inter-Tel
®
5000 Installation Manual – Issue 2.4, May 2008 Page 6-33
SIP and ITP Default Feature Codes
The Show IP feature code displays different information in SIP and ITP modes.
Table 6-21 shows default feature codes when operating in SIP mode.
Table 6-20. SIP and ITP Mode Functions for Show IP Feature
Feature Default Code SIP Mode ITP Mode
Show IP
(or Display
Time/Date)
300 Displays the IP
address of the
endpoint.
Displays the system date and time, extension number, and
status for IP and digital endpoints. The IP address is not
displayed in IP mode.
Table 6-21. SIP Default Feature Codes
Feature Code Feature Code
Answer (Ringing Call) 351 Hold – Individual 336
Call Forward All Calls 355 LCD Contrast 303
Conference 5 Message 365
Do-Not-Disturb 370 Microphone Mute On/Off 314
Do-Not-Disturb Cancel 371 Redial 380
Do-Not-Disturb On/Off 372 Redirect Call 331
Group Listen 312 Reverse Transfer (Call Pick-Up) 4
Headset On 315 Ring Tone Selection 398
Headset Off 316 Transfer To Ring 345
Headset On/Off 317
To Next Page
Loading...
