Muratec MFX-C2280 - [Realtime Preview]; [Preview Display Conditions (Standard Application)]; [Preview Display Conditions (Registered Application)]; [Scan File Name Settings]

Description of Setup Buttons (Administrator Settings) 13-8
13
[Realtime Preview]
To display: [Utility] - [Administrator Settings] - [System Settings] - [Preview Settings] - [Realtime Preview]
Select whether or not to display a preview image for each page when scanning an original in Scan/Fax mode.
Each preview image shows the scanned original as is.
[OFF] is specified by default.
[Preview Display Conditions (Standard Application)]
To display: [Utility] - [Administrator Settings] - [System Settings] - [Preview Settings] - [Preview Display Con-
ditions (Standard Application)]
Select the conditions for displaying preview images.
[Preview Display Conditions (Registered Application)]
To display: [Utility] - [Administrator Settings] - [System Settings] - [Preview Settings] - [Preview Display Con-
ditions (Registered Application)]
Select conditions to display preview images when using an OpenAPI application.
[Scan File Name Settings]
To display: [Utility] - [Administrator Settings] - [System Settings] - [Scan File Name Settings]
Press this button to change the default file name of scanned original data when saving it.
The file name is:"initial of the function" + "text to be added" + "date" + "sequential number" + "page number"
+ "file extension".
Settings Description
[Job Executed] Shows a preview image when pressing Start to execute a job as well as
when pressing Preview.
[Preview Settings Screen] Shows a preview image only when Preview is pressed.
[Preview Settings Screen] is specified by default.
Settings Description
[Job Executed] Shows a preview image when pressing Start to execute a job as well as
when pressing Preview.
[Preview Settings Screen] Shows a preview image only when Preview is pressed.
[Preview Settings Screen] is specified by default.
[Use Standard App. Set-
tings]
Follows the setting of [Preview Display Conditions (Standard Application)].
Settings Description
[Function Mode Initial] Select whether to use an initial of the relevant function as a prefix for the
file name.
For details, refer to page 13-9.
[Supplementary File Name] Select whether to add a device name or desired text to the file name. To
add desired text, enter it.
For details, refer to page 13-9.