Sending a File to a Shared Folder of a Computer (SMB Send) 3-16
3.2 Preparation for SMB Send
3
3.2.3 Machine Side: Steps Required to Use This Function (for the Administrator)
Checking a LAN cable for connection
Check that a LAN cable is connected to the LAN port of this ma-
chine via the network.
Checking the network settings
Check that an IP address is assigned to this machine. Tap [Utility] - [Device Information], and check that an
IP address is displayed.
d Reference
If no IP address is displayed, you need to configure the network. For details, refer to "User's Guide [Web Man-
agement Tool]/[Operations Required to Use Web Connection]".
Configuring the SMB Send environment
Enable the SMB Send function. (You can use this function with the default settings unless otherwise request-
ed.)
How to configure the setting is explained using Web Connection. For details, refer to "User's Guide [Web
Management Tool]/[Configuring the Scan Environment]".
Tips
- In Mac OS X 10.7, configure the following setting.
– Set [SMB Authentication Setting] to [NTLM v1/v2]. For details, refer to "User's Guide [Web Management
Tool]/[Configuring the Scan Environment]".
– Enable the direct hosting SMB service. (You can use this function with the default settings unless oth-
erwise requested.) For details, refer to "User's Guide [Web Management Tool]/[Configuring the Scan
Environment]".
– Synchronize the date and time, including the time zone, between the machine and your computer. For
details on how to set the date and time of the machine, refer to "User's Guide [Web Management
Tool]/[Configuring Basic Information Settings of This Machine]".
To Next Page
Loading...
Need help?
General
