Sending with Web Service (WS Scan) 7-3
7.2 Preparation for WS scan
7
7.2 Preparation for WS scan
7.2.1 Preparation Flow
1 Connecting this machine to the network
% Checking a LAN cable for connection
% Checking the network settings
Check that an IP address is assigned to this machine.
2 Prepare the environment required to use the WS scan transmission function
% Enabling the Web service function
Check the Web service settings and scanner name.
3 Prepare the environment required to use a computer
% Installing the scanner driver
Install a scanner driver used for Web service.
4 Configuring the machine to your environment
% Using SSL communication
If a communication that uses the Web service is encrypted with SSL in your environment, configure its
setting.
% Using a proxy server
When using a proxy server for a communication that uses the Web service, configure its setting.
5 Preparation finished
7.2.2 Machine Side: Steps Required to Use This Function (for the Administrator)
Checking a LAN cable for connection
Check that a LAN cable is connected to the LAN port of this ma-
chine via the network.
Checking the network settings
Ensure that this machine has an IP address assigned to it. Tap [Utility] - [Device Information], and check that
an IP address is displayed.
d Reference
If no IP address is displayed, you need to set up the network. For details, refer to "User's Guide [Web Man-
agement Tool]/[Operations Required to Use Web Connection]".
To Next Page
Loading...
