Muratec MFX-C2280 - Scanning a Long Original ([Long Original]); Specifying the Original Loading Direction ([Original Direction]); Specifying the Original Binding Position ([Binding Position]); Scanning While Removing Dust from the Slit Glass ([Despeckle])

Scan-to-Send Function 1-20
1.4 Scan Option Settings
1
Scanning a long original ([Long Original])
Load a long original that cannot be placed on the Original Glass and that is larger in the feeding direction
than the full standard size (A3 or 11 e 17) into the ADF. There is no need to enter the original size in advance;
the ADF will automatically detect the size.
For details, refer to page 11-23.
Specifying the original loading direction ([Original Direction])
When scanning a 2-sided original etc., you can specify the direction in which the original is loaded so that
the vertical direction is set correctly.
For details, refer to page 11-25.
Specifying the original binding position ([Binding Position])
When scanning a double-sided original, specify the binding position of the original in [Binding Position] to
prevent the binding position from being reversed between the front and rear faces.
For details, refer to page 11-25.
Scanning while removing dust from the slit glass ([Despeckle])
When the ADF scans an original, scanning of the original(s) and removal of dust from the Slit Scan Glass are
performed alternately so that the original is always scanned on clean Slit Scan Glass.
It takes longer to finish scanning, compared to the normal operation.
For details, refer to page 11-24.