Chapter 9 DATA MEMORY
9.1 Setting Memory Type
114 HORIBA
● Interval memory
After step 4. on page 113, follow the steps below to set the interval time:
1. Press the ENTER key.
2. The cursor moves to the time setting field.
3. Press the ENTER key again.
The color of the set part changes; press ↑ or ↓ key to input the values.
Setting range:1 to 999 (sec)
4. Press the ENTER key.
The setting is determined, and the color of the set part changes.
5. Press the F4 (RETURN).
The setting is reflected, and the display returns to the SETUP screen.
6. Press the MEAS key.
The display returns to the Measurement screen.
In setting the Interval memory to ON, it is necessary to set the AutoHold in the Meter SETUP
to OFF (Refer to Page 134)
To Next Page
Loading...