Chapter 10 SECURITY SETUP
10.3 Setting/Performing each option
122 HORIBA
10.3 Setting/Performing each option
10.3.1 User management
Setting the USER MANAGEMENT selection option to ON will require the Operator name in
starting up the system. Also such setting configuration as date setting, security setting change,
data memory deletion in maintenance setting, and/or reset operation for factory shipping will
be only available to the Administrator. The User Control selection option can be set to ON
only by the Administrator.
1. With setting the USER MANAGEMENT selection option ON, press ← or →
key and select OFF or ON.
2. Press F4 (RETURN).
The User Control is switched to ON.
When the Operator has not been registered, the registry menu appears.
When the Operator has been registered, the SELECT OPERATOR menu appears.
When the User Control is ON, Administrator should be careful not to forget the password.
Multiple Administrators should record passwords in case the password should be lost.
10.3.2 Password validity
By switching the Password Validity setting ON, the system notices it is time to change pass-
word when the set duration is over.
Setting the password validity requires the new password registration at 12 p.m. to be set on
the next day from the set date as the starting date of computation.
1. With the PASSWORD VALIDITY option selected, press ← or → key, and
select OFF or ON.
In selecting ON, set the validity.
2. With ON selected, press the ENTER key twice.
The setting can be made.
3. Press ↑ or ↓ key and input the number of days for validity.
Setting range: 1 to 999 days
4. Press the ENTER key.
The setting is determined.
The Password validity is valid only for operators registered after the validity setting.
To Next Page
Loading...