NAVI F-52 - Lockout Count Reset; Reset the Lockout

Chapter 10 SECURITY SETUP
10.3 Setting/Performing each option
124 HORIBA
10.3.5 Lockout count reset
The lockout count reset can set the limit time for the lockout to be reset when the erroneous
passwords are input more than the times set at Password Limit.
1. With the LOCKOUT RESET option selected, press the ENTER key.
The setting is available.
2. Press ↑ or ↓ key, and input the limit time.
The setting unit is minute.
Setting range: 1 to 999 (minutes)
3. Press the ENTER key.
The setting has been made.
10.3.6 Reset the lockout
This section explains how to reset the lockout.
This operation is only available to the Administrator.
With “PASSWORD ERROR” displayed on the screen, follow the steps below.
1. Press F4 (URGENT).
The SELECT OPERATOR screen
appears.
The operator registered as the Admin-
istrator is displayed.
2. Select the appropriate operator,
and press F4 (RETURN).
The password input dialog appears.
3. Input the right password and press
F4 (RETURN).
The lockout state is reset, and the
SETUP screen appears.