Chapter 5 Ion Measurement (F-53,55)
5.2 Measurement Using a Calibration Curve
66 HORIBA
5. Press the MEAS key.
The AutoHold measurement starts.
The HOLD indication starts blinking,
and when the indication stabilizes the
HOLD indication lights up. The indi
-
cation value is held, and the measure-
ment is completed.
The measured value may be in the HOLD
state such as in the instantaneous measure
-
ment or the AutoHold measurement. In this
case press F3 (DATA IN) memorizes the
data. (Refer to
"Chapter 9 DATA MEMORY"
page 113)
Blinking
Lit
To Next Page
Loading...