NEC SL 1000 - Page 134

Item
No.
Item Input Data Description Default Related
Program
23 Least Cost Rout-
ing
0 = LCR Off
1 = LCR On
2 = LCR On (Cost Cen-
ter Code only)
0
24 Trunk-to-Trunk
Outgoing Caller
ID through Mode
0 = Disable (Caller ID
not forwarded out.)
1 = Enable (Caller ID is
forwarded out.)
Enable (1) or Disable (0) the ability
to send the original Caller ID
through when the call is Forward
Off-Premise.
0
25 Continued/
Discontinued
Trunk-to-Trunk
Conversation
0 = Disable (No)
1 = Enable (Yes)
Enable (1) or Disable (0) the ability
to dial a service code to continue or
disconnect the Trunk-to-Trunk con-
versation after the alert tone is
heard.
0 20-28-01
20-28-02
20-28-03
24-02-07
24-02-10
25-07-07
25-07-08
26 Automatic Trunk-
to-Trunk Trans-
fer Mode
0 = Normal Transfer
(Normal)
1 = Step Transfer
(Step)
0 24-02-11
24-02-12
27 Caller ID Refuse
Setup
0 = Disable (CID refuse
will not function.)
1 = Enable
Per trunk enable or disable the abili-
ty to use the caller ID refuse feature.
0
28 Effectively of
"Conversation
Recording Desti-
nation for Exten-
sion"
0 = No Effect (No)
1 = Available (Yes)
1 15-12
30 Flexible Ringing
by Caller ID
0 = Disable (No)
1 = Enable (Yes)
1 13-04
32 Anti-trombone
Function
0 = No Effect (No)
1 = Available (Yes)
0
33 APSU(VM00)
Trunk Receive
Gain
1 ~ 63
(- 15.5 dB ~ + 15.5 dB
in 0.5 dB intervals)
Additional PAD when a trunk call
connects to APSU Voice Mail.
32 (0 dB)
38 Outgoing CLI se-
lection (V3.0 Add-
ed)
0 = Contract Number
1 = Extension Number
2 = Extended Table
3 = PRG21-13
4 = PRG21-18
5 = PRG21-19
6 = No Digits
Shows what number to show. 0 21-13-01
21-18-01
21-19-01
21-25-01
39 CLI composition
(V3.0 Added)
0 = Prefer extension
1 = Combine trunk +
extension
If the flag has the default value 0:
"prefer extension", the extension's
CLI is sent out, if it is not empty. If it
is empty, the trunk's CLI is sent in-
stead.
If the flag has the value 1: "combine
trunk+extension", the trunk's CLI is
stored in the sending buffer, padded
with the extension's CLI.
0
40 ISDN Queue an-
nouncement
connect mode
(V2.0 Added)
0 = send CONNECT
1 = send PROGRESS
#8
When a VRS queue message is to
be played back (configured in PRG
22-14, PRG 22-15, PRG 41-11, or
PRG 41-19, the system shall, in-
stead of a CONNECT message,
send a PROGRESS message in-
cluding a ProgressIE #8 “in-band
tones and announcements availa-
ble”.
0 22-14
22-15
41-11
41-19
SL1000/SL1100 ISSUE 3.01
2-112 Program 14 : Trunk, Basic Setup
Program
14