Use this keypad digit ... When you want to ...
6 Enter characters : M-O, m-o, 6.
7 Enter characters : P-S, p-s, 7.
8 Enter characters : T-V, t-v, 8.
9 Enter characters : W-Z, w-z, 9.
0 Enter characters : 0 ! “ # $ % & ’ ( ) ô õ ú å ä æ ö ü α ε θ В
Enter characters :
+ , - . / : ; < = > ? π Σ σ Ω ∞ ¢ £
# # = Accepts an entry (only required if two letters on the same key are needed - ex : TOM).
Pressing # again = Space. (In system programming mode, use the right arrow Softkey in-
stead to accept and/or add a space.)
Clear/Back Clear the character entry one character at a time.
Flash Clear all the entries from the point of the flashing cursor and to the right.
SECTION 7 USING SOFTKEYS FOR PROGRAMMING
(This Feature is available for IP Phone Only.) (SL1000)
Each Display telephone with Softkeys provides interactive Softkeys for intuitive feature access. The
options for these keys will automatically change depending on where you are in the system
programming. Simply press the Softkey located below the option you wish and the display will change
accordingly.
_
Program Mode
Base Service OP1 OP2
Pressing the Cursor key Up or Down will scroll between the menus.
_
Program Mode
Hard Mtnance
SECTION 8 WHAT THE SOFTKEY DISPLAY PROMPTS MEAN
(This Feature is available for IP Phone Only.) (SL1000)
When using a display telephone in programming mode, various Softkey options are displayed. These
keys will allow you to easily select, scan, or move through the programs.
Table 1-4 Softkey Display Prompts
Softkey Display Prompts
If you press this Soft-
key ...
The system will ...
back Go back one step in the program display.
You can press Cursor Key (UP) or Cursor Key (Down) to scroll forward or backward through a
list of programs.
SL1000/SL1100 ISSUE 3.01
1-6
Introduction
To Next Page
Loading...
